Ace HPE6-A69 Certification with 60 Actual Questions
PASS HP HPE6-A69 EXAM WITH UPDATED DUMPS
NEW QUESTION 26
Which statement is true regarding IP-SLA?
- A. ArubaOS-CX supports Doth SLA configuration through CU and by agents through the NAE.
- B. The default and minimum probe interval for voip SLA is 180 seconds
- C. ArubaOS-CX supports forever tests
- D. ArubaOS-CX supports on-demand as well as forever tests.
Answer: C
NEW QUESTION 27
Refer to the exhibit.
A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?
- A. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.
- B. Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.
- C. Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports
- D. Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.
Answer: A
NEW QUESTION 28
(Scenarios may contain multiple errors which may or may not Impact the solution > Refer to the exhibit.
An engineer has attempted to configure two pairs of switches in the referenced configuration it is required to implement VSX keep-alive at the aggregation layer.
The ports of the ArubaOS-CS 8325 switches used for Agg01 and Agg02 are populated as follows:
The configuration of switch AGG01 includes:
VSX keep-alive is not working. Which modification should you make lo resolve the error condition?
- A. Edit the vsx-sync command, adding "keep-alive"
- B. Edit interface 1/1/48, adding the command "vpn-instance KA"
- C. Modify the Keepalive peer 192.168.20.2 source 192 168.20.1 command, adding "vrf KA"
- D. Modify the Interface lag 2 command, removing "multi-chassis"
Answer: D
NEW QUESTION 29
What are two valid steps in a Proof of Concept plan? (Select two)
- A. Acceptance of the proposed solution
- B. Engineering a proposed solution
- C. Development of the items to Be tested
- D. Definition of success criteria
Answer: C,D
NEW QUESTION 30
The customer has a requirement for creating security filtering for IPv4 and IPv6 traffic passing through an ArubaOS-CX 6400 switch. Which statement Is true about access-list on the selected switch model?
- A. IPv4 and IPv6 entries can be used in one ACL with separate rules
- B. Only one inbound or outbound ACL can be bound to an interface.
- C. Separate IPv4 and IPv6 ACLs need to be created for inbound and outbound traffic
- D. Routed interfaces can have only inbound ACLs
Answer: D
NEW QUESTION 31
How Is voice Traffic prioritized correctly on ArubaOS-CX switches?
- A. By defining voice VLANs inside VLAN context
- B. By placing it in the strict priority queue
- C. By implementing TOS-profiles
- D. By attaching the QoS settings directly to device profiles
Answer: C
NEW QUESTION 32
Which statement is true about NAE scripts'?
- A. The System Resource Monitor is the only script Installed on the system by default.
- B. No script is installed on the system by default.
- C. The Health Monitor is the only script installed on the system by default.
- D. The System Resource Monitor and Health Monitor a/e the only scripts installed on the system by default
Answer: A
NEW QUESTION 33
A customer would like to utilize some ArubaOS-CX 6300M switches to perform OSPF routing.
All ports are routed, and ECMP is enabled, with other default parameters for OSPF. What will be the result of traffic sent from CLIENT-A to CUENT-B?
- A. Traffic will be SW3 -> SW-1 -> sw-4 -> SW-2
- B. Traffic win be SW3 -> SW-1 -> sw-2.
- C. Traffic will be SW3 -> SW-1 -> Sw-2 & SW3 -> SW-4 -> SW-2
- D. Traffic will be SW3 -> SW-4 -> SW-2.
Answer: A
NEW QUESTION 34
When planning a new wired network solution for an organization, mere are technical goals that must be achieved to support the organization objectives and their applications and services.
Which options are valid technical goals? (Select two.)
- A. Accelerate the ordering process of new network hardware.
- B. improve the network throughput
- C. Replace hardware that is reaching end of support with a technology refresh.
- D. Reduce the cost of wiring.
- E. Transform the process of acquisition of a new network solution from a CAPEX to an OPEX model
Answer: A,E
NEW QUESTION 35
Before designing a new network solution for a customer with between 2398 and 5264 employees, you should gamer Information from the customer about their wired network needs.
What are valid questions to determine their wired network needs? (Select two.)
- A. How experienced is your networking team?
- B. Do you plan to add new customer services?
- C. How much do you plan to spend in the new wired network?
- D. What are the current device capabilities and topology?
- E. What is the current cabling deployed in the location?
Answer: C,E
NEW QUESTION 36
An administrator warns to start a REST API session with an Aruba-OS CX switch Which HTTP method should the Administrator use to start a session?
- A. POST
- B. LOGIN
- C. GET
- D. PUT
Answer: A
NEW QUESTION 37
The example ACL is used with Aruba CX 6400 switches to permit traffic to web servers configured on interface 1/1/1 inbound with IP 10.254.4.1/24.
How does this ACL affect the HTTPS traffic to destination 10.254.4.7 from a client 10.253.1.5 via interface
1/1/2 with IP 10 254.3.1/24?
- A. The implicit rule allows the traffic
- B. The traffic is allowed when ACL is Pound to inbound traffic.
- C. The ACL would be valid only if bound to 1/1/2 outbound.
- D. The implicit rules deny the traffic.
Answer: C
NEW QUESTION 38
(Scenarios may contain multiple errors which may or may not impact the solution) Refer to the Exhibit.
An engineer has attempted to configure two pairs of switches m the referenced configuration it Is required to implement Multi-Chassis Link Aggregation for each pair of switches The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows
The configuration includes:
There is an error message stating "mismatched group speed" What should you add to the configuration to correct the error?
- A. "speed 10-full" under interfaces 1/1/12 and 1/1/13
- B. "speed 40-full" under interfaces 1/1/49 and 1/1/50
- C. "allow-unsupported-transceiver
- D. "system Interface-group 1 speed I0g"
Answer: A
NEW QUESTION 39
Which statements are true with regards to Strict Priority scheduling? (Select two.)
- A. Under strict Priority, the port will never forward a packet in a tower priority queue if a higher priority queue includes even one packet.
- B. Strict Priority scheduling protects against starvation of low priority queues.
- C. Strict Priority works best when the network uses the higher priority queues for the majority of applications
- D. Strict Priority must be used with egress queue shaping to prevent starvation.
Answer: A,D
NEW QUESTION 40
The customer is already using Aruba Gateway and third-party L2 switches New ArubaOS CX 6300 switches have been deployed for R&D. which have a requirement for user profiling and tunneled traffic between ArubaOS CX 6300 and Aruba Gateway What is required for this configuration to apply QoS user-based rules for the R&D client traffic?
- A. Create a QoS policy for the UBT-client-VLAN traffic on the third-party switch.
- B. Manually prioritize IP protocol 47 traffic on the third-party switches to prioritize the tunneled traffic
- C. Apply a port-access policy with QoS defined in the user role on the ArubaOS CX6300 switch
- D. Apply a QoS rule to the ArubaCX 6300 client port, lo classify traffic before it is tunneled.
Answer: D
NEW QUESTION 41
After a Proof of Concept where NetEdit was used to troubleshoot the network, the customer agrees that NetEdit meets some of its technical goals.
Which technical goals does NetEdit meet? (Select two.)
- A. improve the network throughput
- B. Minimize network downtime
- C. improve the network's scalability
- D. improve reliability of mission-critical applications
- E. Simplify network management
Answer: B,D
NEW QUESTION 42
What are the requirements for managing a switch using Aruba NetEdit? (Select two)
- A. Telnet must be disabled on the switch
- B. HTTPS service must be restricted to the management VRF
- C. The switch user account mat NetEdit uses should have a password.
- D. REST access-mode must be set to read-write.
Answer: A,D
NEW QUESTION 43
......
HPE6-A69 Questions PDF [2023] Use Valid New dump to Clear Exam: https://examtests.passcollection.com/HPE6-A69-valid-vce-dumps.html
